Ofm 580 User Manual download pdf

Chair Back

1 Unit

Chair Seat

1 Unit

Chair Base

1 Unit

Casters

5 Units

Headrest

1 Unit

Adjustable Arms

2 Units

Gas Lift

1 Unit

Seat Mechanism

1 Unit

Telescopic Bellows

1 Unit

8x30mm Screw

4 Units

8x25mm Screw

4 Units

6x25mm Screw

6 Units

Washer

6 Units

Headrest Screw

2 Units

Screw Cap

2 Units

Assembly Notes:

During assembly, hand tighten screw only when all screws

are in place, you may then tighten all screws completely.

CAUTION:

1. Do not use this chair as a step ladder.

2. Check for loose screws and tighten them every 6 months.

Model 580 Contemporary Executive Mesh Chair with Headrest

WEIGHT CAPACITY: 250 lbs.

Parts Listing

919-362-4765 (fax)

www.ofminc.com

161 Tradition Trail Holly Springs, NC, 27540

800-520-7471 (voice)

919- 303-6389 (voice)

[email protected]

06.14.2010

N O

Assembly Instructions

Tools Needed: Phillips Head Screwdriver

Please read all instructions before assembly.

Step 1: Insert Casters (D) into Base (C). Insert Gas Lift (H) into Base (C), and cover with

Telescopic Bellows (I).

Step 2: Place Chair Seat (B) upside-down on a level, non-abrasive surface and align pre-drilled

holes in Seat Mechanism (G), with holes in Chair Seat (B). Insert four 8x30mm Screws (J)

through the holes in the Seat Mechanism (G) and into the Chair Seat (B).

Step 3: Connect Chair Back (A) to Chair Seat (B) by attaching the J-bar on the Chair back onto

the bottom of the Chair Seat (B) and Seat Mechanism (G), using three 8x25mm Screws (K).

Step 4: Attach Adjustable Arms (F) to the bottom of the Chair Seat (B) by inserting 6x25mm Screws (L)

through Washers (M) and through holes in Arms (F) into the holes in the Chair Seat (B).

Step 5: Carefully place Chair Seat (B) with attached Seat Mechanism (G) onto the Gas Lift (H) by

aligning the hole in the Seat Mechanism (G) with the top of the Gas Lift (H). Carefully sit

on chair to make sure the Gas Lift (H) is properly inserted into the Base (C). Operate the

Gas Lift Lever on the Seat Mechanism (G) to be sure unit is working.

Step 6: Attach Headrest (E) to the Chair Back (A) using two Headrest Screws (N). Cover

screwholes with Screw Caps (O).

STOP

Assembly Instructions 1

Summary of Contents

Page 1 - Assembly Instructions

AChair Back1 UnitBChair Seat1 UnitCChair Base1 UnitDCasters5 UnitsEHeadrest1 UnitFAdjustable Arms2 UnitsHGas Lift1 UnitGSeat Mechanism1 UnitITelescopi

Comments to this Manuals

No comments

Ofm 580 User Manual

Browse online or download User Manual for Furniture Ofm 580. OFM 580 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Furniture Ofm 580