Ofm GT4794 User Manual download pdf

Table Top

1 Unit

Center Support Beam

1 Unit

Support Braces

2 Units

Legs

2 Sets

Leg Screws

18 Units

Mounting Stud

10 Units

Model GT4794 Glass Conference Table - 47” x 97”

Parts Listing

919-362-4765 (fax)

www.ofminc.com

161 Tradition Trail, Holly Springs, NC, 27540

800-520-7471 (voice)

919- 303-6389 (voice)

[email protected]

07.11.2012

STOP

Assembly Instructions

Tools Needed: 7/32” Allen Wrench

*You will need at least 3 people to assemble this table. DO NOT attempt to

assemble by yourself.

Please read all instructions before assembly.

Step 1: Using three people, very carefully lay the Table Top (A) upside

down on a flat, clean surface. Attach the Center Support Beam (B)

to the mounting plates on the Table Top (A) by inserting Support

Screws (E) through Center Support Beam (B) and Mounting Stud (G),

and into mounting plate. Repeat for other side.

Step 2: While one person holds up the Legs (D), attach the Legs (D) to the

mounting plates on the Table Top (A) by inserting Leg Screws (F)

through holes in the Legs (D) and into the Center Support Beam (B).

Please note that two go into the Support Beam (B) and one goes

into the Leg (D). Only hand tighten Screws (F). Repeat for other side.

Step 3: Secure Legs (D) by lining up Support Braces (C) with holes on

the Legs (D) as shown.

*Please make note of the distinction between the mounting holes

on the Support Braces (C). Two corners have a severe angle,

while one corner is less severe. The two matching corners should

attach to the Legs (D) as shown.

Attach by inserting Leg Screws (F) through Support Brace (C) and

into Legs (D). After attaching Support Braces (C) to both Legs (D)

on one side, line up remaing corner on Support Brace (C) with hole

on Center Support Beam (B) and attach by inserting Leg Screw (F)

through Support Brace (C) and into Center Support Beam (B).

Repeat for other side. Securely tighten all screws in table.

Support Screws

10 Units

Assembly Notes:

During assembly, hand tighten screws only. When all screws

are in place, you may then tighten all screws completely.

CAUTION:

1. Do not use this table as a step ladder.

2. Check for loose screws and tighten them every 6 months.

ATTENTION: After assembly, 3-4 people are

required to turn table right side up.

Total Weight of Table: 274 lbs.

Assembly Instructions 1

Summary of Contents

Page 1 - Assembly Instructions

ATable Top1 UnitBCenter Support Beam1 UnitCSupport Braces2 UnitsDLegs2 SetsFLeg Screws18 UnitsGMounting Stud10 UnitsModel GT4794 Glass Conference Ta

Comments to this Manuals

No comments

Ofm GT4794 User Manual

Browse online or download User Manual for Furniture Ofm GT4794. OFM GT4794 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Furniture Ofm GT4794